PPG presents low-temperature cure coating technology in Asia
The group has shown a coating that cures at lower temperatures — a claim whose value depends entirely on what the energy saving actually is.
PPG has presented a low-temperature cure coating technology at SURCAR Asia 2026, according to the company’s newsroom.
Low-temperature cure matters because heat is cost. A coating that crosslinks properly at a lower oven temperature saves energy per part, allows heat-sensitive substrates to be coated, and shortens cycle time. All three claims are testable, and none of them has been verified here: the announcement as seen by ArtCoatings does not state the temperature reduction, the substrates covered, or the durability achieved.
SURCAR is an automotive finishing event, so the technology is presented for automotive applications rather than for architectural decorative work.
Why this matters
Cure technology developed for automotive lines eventually migrates. The same chemistry constraint — curing properly without excessive heat — applies to factory-applied finishes on joinery and panels, which are a growing part of the decorative supply chain.
What remains unconfirmed
- The temperature reduction achieved and at what cycle time.
- Which substrates the coating has been tested on.
- Whether durability matches the conventional cure it replaces.
Source & editorial note
- Source
- PPG Industries (Newsroom)
- Source reliability
- Medium
- Last reviewed
Read the original report — external site, in the source publisher's own words.
This article is a summary prepared by the ArtCoatings editorial desk from the source named above. It is second-hand reporting: figures, dates and quotations are reproduced as published by the source and have not been independently verified unless stated in the text.